DW Spectrum User Manual

Key Concepts:

•When the event rule is true and valid, all devices will record at their maximum resolution.

•Action can persist for a fixed duration or a duration of time relative to the event.

Additional Settings:

Below the action type is the duration mode:

•For the duration of the event will provide the device output from event beginning to event end.

•Of fixed duration will enable the additional options below:

Begin When:

The Begin When setting appears only for supported events and the following options will varying by event type:

•When event occurs is the moment an instantaneous events occurs.

•When event starts is the moment the event rule became true and valid.

•When event stops is the moment the event rule was no longer true and valid.

Duration:

Select the duration of the action and the unit of time measurement.

Interval of Action:

To avoid overlapping actions, enable the interval of action and set the Once in duration to be longer than the execution time of the action.

•Move the slider switch to enable or disable the interval of action control.

•If enabled, a numerical value for the interval of action and a unit of measurements is required.

Dialog Controls:

•Click Apply to update the event rule and keep the dialog open.

•Click OK to save settings and close the dialog.

•Click Cancel or use the close window control to discard any changes not applied and close the dialog.