Occurs if input signal is detected on one or more device(s). DW Spectrum can detect input signals on the following devices:
•ONVIF-compliant (input support via ONVIF may vary from device to device)
•Axis cameras
IMPORTANT: To detect input signals, input must be supported on the device.
Basic Parameters
•When – A signal can be continuous, so the event must be defined as occurring when input "Starts" or "Stops".
•At – Device(s) the input signal is detected on. To specify devices see Selection Lists in Event Rules. Choose <Any Device> to detect input signals on all devices supporting that input.
Note: A warning notification will open if one or more of the selected cameras does not support this event. These cameras will be highlighted in red.
Advanced Parameters
•Input ID – the I/O Module port to take signal from (see Setting Up I/O Modules).
Why Event may work incorrectly
•Too many devices are being monitored, causing too many events to occur.
•Devices that are being monitored are offline.
•Action is not configured properly.
•Global notification for this event is disabled.